Slide the shield supports into the pockets in the shield brackets on the traction.

Farmer-HelperSG24 Stump Grinder 10 Revision REPLACING TEETH 1. Disconnect the PTO shaft from the tractor and set the stump grinder on a flat and level surface.

2. Remove the lock nut using a wrench or socket. 3. Remove the cutting tooth.

Each tooth is indexed with 3 positions so that you can rotate it twice, exposing a new sharp edge before replacing the tooth.

4. Install a replacement tooth and lock nut using a torque wrench set to ft-lbs ( Nm). Owner's Manual Instructions for Operation, Maintenance Compact Stump and Root Grinder Your NorthStar grinder is intended for outdoor-use only and can be used to remove many tree stumps and exposed root systems close to ground level.

By moving the blade in sweeping movements laterally. Move the grinder to the other side of the stump to continue removal or by filling the hole with chips before continuing.

You will want to prepare the grinder at the stump by placing it into position with the cutting wheel near the top edge of the stump. (See image below) Removing Roots 1. Make sure the throttle is set to fast. The cutter wheel will accelerate to cutting.

Owner's Manual Instructions for Operation, Maintenance Self-Propelled Stump and Root Grinder BOE (SPHE) & BOE (SPKE) Your Dosko grinder is intended for outdoor-use only and can be used to remove tree stumps and exposed root systems close to ground level.

The stump grinder has 4 sets of mounting holes for positioning the chip guard Figure

By moving the wheel in sweeping movements laterally over. OperatOr and parts Manual Stump Grinder Models W, W & WH 3 Table of Contents - Stump Grinder Warranty Policy 4 # Cutting Teeth 33 33 42 Gearbox Ratio Gearbox (hp rating) 60 hp 60 hp hp When the stump grinder is transported on a road or highway at night or during the day, safety.